Ikelite Film Camera Film Camera User Manual

CONNECTING THE STROBE_____________________________________  
1. Make sure all components are dry.  
IKELITE SINGLE CORD/  
NIKONOS-STYLE #4104.6  
2. Clean and lightly lubricate the stem o-ring and the strobe  
Stem O'ring  
connector threads. Check the o-ring for nicks or cuts.  
SINGLE SYNC CORD #4104.6  
____________________________________  
3. Note the positioning of the receptacles and pins.  
Retaining  
Ring  
Properly align the end of the sync cord and insert into  
Connects a single (1) Ikelite Substrobe to a Nikonos IV, V, RS camera or  
suitable FILM camera housing that utilizes the Nikonos-style flash socket  
for external strobe connection. The strobes will fire in TTL automatic or  
manual exposure modes using the Nikons V or RS. Strobes will only work  
in the manual mode with the Nikonos IV or camera housings.  
the strobe connector.  
4. Hand-tighten the Retaining ring on the sync cord.  
5. Push the connector body further into the strobe connector  
and continue to tighten the Retaining ring.  
CONNECTING TO THE CAMERA OR HOUSING____________________  
1. Make sure all components are dry. Clean and lightly  
lubricate the stem shaft, o-ring and retaining ring threads.  
Check the stem o-ring for nicks or cuts.  
Index Groove  
Stem O'ring  
2. Align the index groove with the Indexing Pin of the flash  
socket, and insert the stem into the flash socket.  
3. Rotate the retaining ring counter clockwise until it  
mates with the flash socket threads. Then carefully  
rotate retaining ring clockwise and thread it into the  
flash socket until snug.  
Red Retainer  
O'ring  
Retaining  
Ring  
Nikonos Style  
Connector  
LIMITED WARRANTY___________________________________________  
All Ikelite products are warranted against any manufacturing defects for  
a period of one (1) year from the date of purchase. Defective products  
should be returned prepaid to Ikelite. Ikelite will, at its discretion, repair or  
replace such products, and will return to customer prepaid. All other claims,  
of any nature, including but not limited to bulb failure are not covered. Except  
as mentioned above, no other warranty expressed or implied, applies to this  
Ikelite product.  
ONLY IKELITE TTL SUBSTROBES CAN BE CONNECTED.  
DO NOT use the TTL cord on a non TTL strobe; you will damage  
the camera.  
remove the sync cord from the strobe or camera underwater  
or when wet. Connections are NOT waterproof when  
DO NOT  
disconnected underwater.  
DO NOT leave the cord connected  
for prolonged periods. Otherwise,  
the cord may freeze to the strobe  
or camera. After each dive,  
disconnect the cord and lightly  
lubricate the connector threads.  
Never use spray lubricant.  
IKELITE UNDERWATER SYSTEMS  
50 West 33rd Street, P.O. Box 88100,  
Indianapolis, IN 46208 USA  
(317) 923-4523  
4104.6-01-0706  
 

Greenheck Fan Smoke Alarm DH100ACDCLP User Manual
Greenheck Fan Ventilation Hood DFD FD Series User Manual
Grizzly Lathe ML 33607 User Manual
Hamilton Beach Mixer 63222CH User Manual
Harman Kardon CD Player HD710 User Manual
Healthrider Treadmill HRTL11940 User Manual
HP Hewlett Packard Weather Radio HP 85031B User Manual
Husky Work Light HSK141HD User Manual
Husqvarna Motorcycle SM 400 450 R 2004 User Manual
IBM Printer Type 7977 User Manual